Hobby Eagle A3-L V1 or V2 Flight Controller for RC Plane
here we have Hobby Eagle A3-L Flight Controller for RC Plane. V2 is also available.
A3-L Supports 3 flight modes, you can switch between them using a 3-way switch on the transmitter. But if you are using a 2-way switch instead then you can only use 2 of them during flight. The color of the LED shows you that the flight mode currently selected, as shown below.
3 Flight Modes: Normal, 3D AVCS and Gyro Off Mode.
Standard wing type, Delta-wing and V-tail.
Remote Master Gain.
Servo Frequencies: 50Hz/125Hz/250Hz；
Separated gain adjustment for each flight mode.
Automatic stick centering.
HV (7.4) operating voltage supported.
Futaba S.Bus / S.Bus 2 supported.
Easy to use, extremely well-suited to beginners.
When the gyro is activated, you might see that the range of movement of the servo become much larger than before when moving the sticks. This is normal but not a problem because a rotation rate set point has been applied to the outputs by the gyro. The sticks are not only used to control the movement of the surface, but also the rotation rate of the plane in that axis. Anyway the controller will not change the settings of dual rate or expo in your transmitter. The settings will always work in any flight mode.
Caution Notes
Please confirm the 13-bit unique product series number (S/N) on the bar code label when purchasing. This number can be verified at our website and it is also required in the after-sale service, please keep it securely!
Before power on, put the aileron, elevator and rudder sticks in the middle position. The controller needs to perform self-calibration and stick centering after you plugging the battery, the LED will keep blinking Blue rapidly for about 3 seconds while calibrating, just don't move the plane and the sticks until the initialization is done.
It's extremely important to verify that the gyro reacts in the correct direction before flight, or it could lead to losing control or even crash during flight!
You need to restart the controller after changing the receiver type to make new setting take effect.
Never use the delta-wing or V-tail mixing functions of your transmitter.
The new A3 series supports a wide working voltage from 5 to 7.4V, you can use HV receiver or servo directly.
The radio control models are not toys. The propellers rotate at high speed and pose potential risk, please carry out debugging and flying in open space far away from the crowd. The beginner should be directed by someone experienced.
Specifications
Input Voltage: 5 to 7.4V
Servo Travel: 1520 ± 500μs
Gyroscope: ± 2000dps
Operating Temp: -40 ℃ ~ 85 ℃
Size: 43 × 27mm
Weight: 11 g
