ZeroTech Retracting Gear with UBEC and controller
Features: The retracting gear weighs 620g, including the UBEC and the controller.
Features are as below:
High strength, quick installation without soldering.
To avoid damage to the gimbal, it will not retract when power on.
Operation
Auto retracting function only available in double pilot mode, on the gimbal Tx.
Wiring and settings steps:
1. For the wiring, please kindly refer to the wiring diagram below.
Note: use the wiring clip to fasten the connector to void the connectors dropping.
2. Connect the servo lead of the left and right retracting gear servo to the “L SERVO” and “R SERVO” port on the controller. The controller is powered on by the 6V output of the UBEC power module, the lead connects to POW(black wire upside)
3. The input signal lead of the controller connects to the CH7 of the gimbal receiver.
4. Set the CH7 on the Tx Radio, for example, the LD.
